Hi lads, just wondering if anyone has experienced any problems with Unicorn Points fitting darts? I got a set of Unicorn Board Gripper points to put into my Devon Petersons (Unicorn). Got the standard points out of the Petersons no problems but the Board Gripper points wouldn't fit into the barrel when I tried.
I used a Rivet Gun to remove the point, following the tutorial that was posted here (by Danny I think) but the point would not go into the barrel. It would sit down about 2mm into the barrel but when I tried to drive it down further, the point wouldn't budge. I was trying to be gentle so didn't hit it too hard. When i finally did strike it harder, the point bent in the barrel without going in further. Am I doing something wrong when putting in the point or are there issues with points only fitting certain barrels?