Here are the portable stands that me and a buddy made for our tournament. I've got some pics but they aren't the best as we had to take them with my friends phone. I will take better ones when we set up for our tourney. Anyways you need 5 - 2x4 8'and plywood. Cut 4 of them into 6' pieces for the legs and cross pieces. The remaining one cut in half for the feet. The 2' sections left over from the 4 6' sections will be used for the braces on the legs. Nail the 2 4' pieces to the bottoms of the legs and use 2' pieces cut at 45° angles for the braces on each leg. The 2 cross pieces 1 gets put at the very top and the other was put at 50" up from the floor. The backboards were made with the plywood 30" wide x 36" tall placed with the bottom of each set level with the bottom cross piece. Measure in 18" from the leg for where you will set the edge of your backboard and thats it done. Each 6' section hold 4 boards. And you dont have to but I used 2" foam insulation basement board to make surrounds for each Dart board. This stuff is expensive but I went to my local lumber supplier and they gave me damaged ones for free.
So here's the pics just give me a shout if you have any questons.The light holders were made just using some strapping we had layin around.

Cheers,
Hat
[img][You must be registered and logged in to see this image.][/img]
[img][You must be registered and logged in to see this image.][/img]
[img][You must be registered and logged in to see this image.][/img]
[img][You must be registered and logged in to see this image.][/img]

Look great hat!

Looks fine to me! good job Lorne!

Nice job Hat

How sturdy were they, I made one similar last year out of floor boards and joists as we had the living room floor ripped out due to flooding, so used left overs, real solid stuff but due to the weight of it it was quite wobbly when the darts hit.

That was one of the reasons we went with separate 6ft. sections as opposed to 1 long 12ft. section. They were a little wobbly until we attached the backboards and now they dont move not even one little bit!! Very pleased with the outcome.

Hat

Hatrick wrote:

That was one of the reasons we went with separate 6ft. sections as opposed to 1 long 12ft. section. They were a little wobbly until we attached the backboards and now they dont move not even one little bit!! Very pleased with the outcome.

Hat

Great stuff

The ones I'm used to playing on the most are made out of 1" galvanized pipe. Very sturdy

would like a build tutorial if possible please, I want a better one than the one I have, it wobbles like crazy!

Next time I play at my home club on a Wednesday night, I will get some pics and measurements from our free standing frames. Thats what we play on at our club.

bump